Top view after some trimming on the sides and back.
Bottom view.
Roughly where it will go on the car.
From the front, it's a pretty close fit when the vent is open.
Wednesday, April 6, 2011
Possible roof scoop and mockup
This is a plastic piece that came from a 24 volt lawnmower, but it looks like a scoop to me. I don't know if I'll keep it or just use it until I decide to pony up for the Subaru type roof scoop but it was free and I'll make the mounting brackets use holes I've already made.
Top view after some trimming on the sides and back.
Bottom view.
Roughly where it will go on the car.
From the front, it's a pretty close fit when the vent is open.
Top view after some trimming on the sides and back.
Bottom view.
Roughly where it will go on the car.
From the front, it's a pretty close fit when the vent is open.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment